Grass Cutting - GGP ITALY SD98 Gebrauchsanweisung

Gradually reach the desired speed using the
throttle and gear lever.
To change gear, press the clutch halfway
down ( 4.21).
Hydrostatic transmission
Disengage the parking brake and release the
brake pedal ( 4.31).
Press the drive pedal (
«F» and reach the required speed by pro-
gressively increasing pressure on the pedal
and moving the accelerator.
WARNING!
gaged as de scribed (
vent sudden engagement from causing
tipping up and loss of control of the ve­
hicle, particularly on slopes.
5.4.3 Braking
First reduce the machine's speed by reducing
the engine's r.p.m., and then press the brake
pedal ( 4.21 or 4.31) to slow down the ma-
chine until it stops.
Hydrostatic transmission
The machine already slows down consider-
ably by just releasing the drive pedal.
5.4.4 Reverse
IMPORTANT
gaged only when the machine has stopped
moving.
Mechanical transmission
Press the pedal until the machine stops and
then go into reverse by shifting the lever
sideways and into position «R» (
Gradually release the pedal to engage the
clutch and then begin moving in reverse.
Hydrostatic transmission
When the machine has stopped moving, start
reversing by pressing the drive pedal in direc-
tion «R» ( 4.32).
4.32) in direction
Drive must be en­
4.32) to pre­
Reverse must be en-
4.22).

5.4.5 Grass cutting

1
A = 10 mm
A = 30 mm
Adjust the position of the anti-chipping wheels
according to how irregular the ground is.
4
1
The anti-chipping wheels are used to reduce the
risk of tearing up sections of lawn, which can
occur when the edge of the cutting deck drags
over irregular ground.
The four different heights of the wheels allows
you to maintain a safe distance between the cut-
ting deck edge and the ground.
To change the position, unscrew and remove the
screw (2) and reposition the wheel (1) with the
spacer (3) in the hole at the desired height; then
tighten the screw (2) onto the nut (4) as far as
possible.
WARNING!
done to both wheels, WITH THE ENGINE
OFF AND THE BLADES DISENGAGED.
To start cutting:
– move the throttle to «FAST»;
– raise the cutting deck as high as possible; only
use the blade (
use the blades on stony ground or when the
grass is very high.
– start moving forwards on the grass very slowly
and with utmost caution, as already described;
– regulate the cutting height and speed
( 4.6) considering the conditions of the
lawn (the height, density and dampness of the
grass).
A = 0 mm
A = 20 mm
A
3
2
This work is to be
4.5), on grass lawns, do not
EN 17