Grass Cutting - GGP ITALY 102 Gebrauchsanweisung

5.4.2 Starting and moving without mowing
WARNING!
This machine has not been approved
for use on public roads. It has to be used (as indicated
by the highway code) in private areas closed to traffic.
When moving the machine:
– disengage the blades;
– bring the cutting deck to the highest position (position «9»);
– put the accelerator control between the «SLOW» and
«FAST» positions.
– disengage the parking brake and release the brake pedal
( 4.31).
– press the drive pedal (
required speed by progressively increasing pressure on the
pedal and moving the accelerator appropriately.
WARNING!
Drive must be engaged in the way
already described ( 4.32) to prevent sudden engage-
ment from causing tipping up and loss of control of the
vehicle, particularly on slopes.
5.4.3 Braking
First, reduce the machine's speed by reducing the engine's
EN 22
4.32) in direction «F» and go to the
r.p.m. and then push the brake pedal (
reduce the speed until the machine stops.
NOTE
The machine already slows down con-
siderably by just releasing the drive pedal.
5.4.4 Reverse
IMPORTANT
Reverse must be engaged only when the
machine has stopped moving.
When the machine is stopped, start the reverse movement by
pressing the drive pedal in the «R» direction (

5.4.5 Grass cutting

Adjust the position of the anti-chipping wheels according to
how irregular the ground is.
The anti-chipping wheels are used to reduce the risk of tearing
up sections of lawn, which can occur when the edge of the
cutting deck drags over irregular ground.
A = 10 mm
A = 30 mm
4.31) to further
4.33).
1
A = 0 mm
A = 20 mm
A