GGP ITALY 102 Gebrauchsanweisung Seite 59

UNPACKING AND ASSEMBLY
IMPORTANT
in, never start the engine until the battery is fully charged!
WARNING!
safe handling and disposal.
3.5 GRASS-CATCHER SUPPORT
ASSEMBLY
Fit the two brackets (1) on the rear plate (2),
using for each bracket three screws (3)
which are supplied, as shown, without fully
tightening the nuts (4).
Attach the grass-catcher to the brackets and
centre it with the rear plate (2). Adjust the
position of the two brackets (1) to the stop
(5) so that, when turning the grass-catcher
frame, the pin (6) slots into the seat (7) cor-
rectly.
Having checked that the grass-catcher
rotates as above, tighten the fixing nuts (4)
securely.
3.6 ASSEMBLING THE LEVERS
FOR TIPPING THE GRASS-CATCHER
Electrical tipping
Position the lever axle (1) in the notch of
the two plates (2) and attach them on the
internal side of the grass-catcher sup-
ports (3), using the included screws (4) in
the sequence shown.
Connect the end of the rod (5) of the lift-
ing piston to the lever (6) with the pin (7)
and attach the two snap rings (8).
Before attaching the grass-catcher to its
supports, make sure that the tipping lever
moves properly.
To prevent the safety device in the electronics card from cutting
Follow the battery manufacturer's instructions regarding
1
3
5
1
4 3 4
8 (x 2)
1 2
EN
4
7
6
1 4 3 4
8 7 5
6 8
11
2