GGP ITALY 102 Gebrauchsanweisung Seite 74

26
EN
When moving the machine:
– disengage the blades;
– bring the cutting deck to the highest position (position «7»);
– put the accelerator control between the «SLOW» and «FAST» positions.
Mechanical transmission
( 4.21) and move the gear change lever into 1st gear (
Keep the pedal pressed down and release the parking brake. Slowly release the
pedal to shift from «brake» to «clutch», thus operating the rear wheels (
WARNING!
engagement may cause the vehicle to tip over and the driver to lose control.
Gradually reach the desired speed using the throttle and gear lever. To change gear,
press the clutch halfway down (
Hydrostatic transmission
brake pedal (
Press the drive pedal (
gressively increasing pressure on the pedal and moving the accelerator.
WARNING!
sudden engagement from causing tipping up and loss of control of the vehi-
cle, particularly on slopes.
5.4.3 Braking
First, reduce the machine's speed by reducing the engine's r.p.m. and then push the
brake pedal ( 4.21 or 4.31) to further reduce the speed until the machine stops.
Hydrostatic transmission
NOTE
ing the drive pedal.
The pedal has to be released gradually, as a sudden
4.31).
4.32) in direction «F» and reach the required speed by pro-
Drive must be engaged as described (
The machine already slows down considerably by just releas-
Push the pedal down as far as possible
4.21).
Disengage the parking brake and release the
HOW TO USE THE MACHINE
4.22).
4.21).
4.32) ) to prevent