Interventions On The Machine; Replacing Wheels - GGP ITALY 102 Gebrauchsanweisung

MAINTENANCE

6.3 INTERVENTIONS ON THE MACHINE

6.3.1 Cutting deck alignment
The cutting deck should be
properly set to obtain a good
cut.
If the cut is uneven, check the
tyre pressure.
If this is not sufficient to
achieve an even cut, please
contact your Dealer for the
adjustment of the alignment
of the cutting deck.
6.3.2 Adjustment of the spring of the pawl
for hooking the grass-catcher
If the grass-catcher tends to jump about and to open
up when going over rough ground, or if it has difficulty
in hooking back on after being emptied, the tension of
the spring will need to be adjusted (1).
Change the hooking point by using one of the holes (2)
until the required result is achieved.

6.3.3 Replacing wheels

Stop the machine on flat ground and put a block under
a load-bearing part of the frame on the side that the
wheel is to be changed. The wheels are held by a snap
ring (1) which can be eased off with a screwdriver.
NOTE
rear wheels, make sure that any differences in their
external diameter does not exceed 8-10 mm; on the
If you have to replace one or both
1
2
37
EN
1
2