Adjusting The Parking Brake; Cleaning - InterCo SIMPLY LIGHT Bedienungsanleitung

Important: Depending on the version, the front and rear wheels require different
tyre pressures�
7.2 Adjusting the parking brake
Tool: Size 8 spanner
Prerequisite: Insufficient braking power of the parking brake; SIMPLY LIGHT can
be pushed even though the parking brake is applied�
To adjust the parking brake, proceed as follows:
Make sure that the parking brake is not applied; if necessary, release the

parking brake (see section 6�8�2)�
The Bowden cables of the parking brakes are routed through an adjusting

bolt before the brake backing plates, which allows an adjustment of the
braking power�
By turning this bolt anti-clockwise, the brake cable is brought under

greater
tension, pre-tensioning the brake� The adjusting bolt is secured by a nut�
Before adjusting the brake, release the securing nut by turning it to the left

(depending on the version, a size 6 spanner may be required)�
Next, turn the adjusting bolt anti-clockwise until it becomes more difficult

to turn the wheel� To check, lift the SIMPLY LIGHT on one side and turn the
respective wheel with your other hand�
Then, turn the adjusting bolt clockwise until the wheel which has to be

adjusted runs freely again�
Turn the counter nut located on the thread of the adjusting nut clockwise

as far as it will go�
If necessary, repeat the procedure for the other wheel�

Advice: In order to check the adjustment of the brake, pull the brake lever several
times before finally fastening the counter nut� If necessary, you have to repeat
this operation, as some experience is required to carry out the adjustment�
7.3

Cleaning

SIMPLY LIGHT features a robust plastic coating� All parts can be cleaned with
soap suds and a soft sponge� Avoid aggressive agents or abrasives as the surface
of the plastic coating may be damaged� To disinfect SIMPLY LIGHT, any conven-
tional disinfectant can be used�
MAINTENANCE AND CARE
43