F) Aligning The Model; G) Mounting The Landing Gear - Reely SKY Tiger Moth Bedienungsanleitung

f) Aligning the Model

First check whether the lower wing is seated correctly. The
arrow marking on the lower wing (see figure 15, item 7) must
correspond precisely to the fuselage seam.
Use non-expandable thread or yarn to check if the two "A"
areas are the same length. For correction, only move the
rear edge of the lower wing towards the fuselage.
Afterwards, the tail unit's distance to the fuselage tip is veri-
fied. The two "B" segments must have the same length (see
sketch A).
At the same time, the elevator has to form a right angle with
the vertical tail (see sketch B).
When the tail unit is correctly aligned, the elevator is se-
cured at the right and left of the fuselage with the included
adhesive strips.
Practical advice:
Fasten the two tail units additionally with a drop of hard foam
superglue after alignment.

g) Mounting the Landing Gear

The landing gear wire (1) is inserted into the prepared land-
ing gear shaft (2) located right behind the flight battery shaft
on the bottom side of the fuselage (also see figure 19).
Since the wire is very tense in the shaft, additional securing
is not required.
52
A
B
A
B
B
A
Figure 16
Figure 17