D) Basic Information Relevant To The Control Of Model Helicopters - Reely SKY EC-135 Bedienungsanleitung

The receiver/controller component then carries out an inter-
nal alignment that lasts for approx. 5 seconds. During this
time, the receiver/controller component's control LED (1) on
the helicopter cockpit flashes red.
The helicopter must not be moved during this
time.
When the alignment is completed, both rotor control servo
motors run in neutral position (centre position) and the con-
trol LED is lit green permanently.
Now your model is ready to start.
Attention!
If the control LED (see figure 6, item 1) changes from green to red during flight, you have to charge your
model immediately to prevent damaging deep discharging of the flight battery.
Caution, important!
Before starting to fly your model helicopter, you should take note of the following information first.

d) Basic Information Relevant to the Control of Model Helicopters

Before you fly your model, you should first familiarize yourself with the control possibilities open to you and thereby be
able to fly safely. The model helicopter is controlled via the two control sticks at the transmitter.
The following functions are available (see next pages).
Figure 6
39