E) Checking The Aileron Linkage - Reely SKY Tiger Moth Bedienungsanleitung

e) Checking the Aileron Linkage

First take up operation of the transmitter and afterwards
connect the charged flight battery to the model. The trim-
ming lever for the engine function (see figure 3, item 11)
must be in the bottom-most position for this.
If the control stick for the elevator and aileron functions (see
fig 3, item 3) at the transmitter is moved to the right and left,
both ailerons (1) must deflect downwards and upwards.
If the control stick and trim slider for the aileron function are
in their central positions, both ailerons must form one level
with the lower wing (2).
The aileron must not be angled slightly to the top or bottom.
The servo lever (3) at the aileron servo must be at a 90°
angle to the longitudinal axis of the fuselage (4). If this is not
the case, remove the fastening screw of the servo lever (5),
lift the servo lever off and screw it on again in the correct
position.
Slight slant of the ailerons can be corrected by adjusting the
linkage length. For this, the clevises (6) are removed from
the aileron laces, twisted in the required direction and then
attached again. The process may have to be repeated sev-
eral times until the correct linkage length is set.
Figure 15
Disconnect the flight battery before performing any adjustments to the aileron linkage!
51