Setting Up The Transmitter; A) Aligning The Transmitter Aerial; B) Inserting The Batteries/Rechargeable Batteries; C) Charging The Rechargeable Batteries For Transmitter - Reely SKY YAK54 Bedienungsanleitung



9. Setting Up the Transmitter

In the operating instructions, the numbers in the text always refer to the figure opposite or the figures within
the section. Cross-references to other figures will be indicated by the corresponding figure number.

a) Aligning the Transmitter Aerial

Angle the transmitter's aerial (see figure 2, item 1) to the side, so that the aerial is at a 90° angle to the connection line
remote control/model. This is how you will achieve best signal transmission. Avoid directing the tip of the transmitter
aerial directly at the model.

b) Inserting the Batteries/Rechargeable Batteries

For the power supply of the transmitter you will need 8 alkaline batteries (e.g. Conrad Item No. 652507, pack of 4,
order 2) or rechargeable batteries mignon size (AA). For ecological and also for economical reasons it is recommended
to use rechargeable batteries, since they can be recharged.
To insert the batteries or rechargeable batteries, please proceed as follows:
The battery compartment lid (1) is located on the back of
the transmitter. Press the corrugated area (2) and push off
the lid downwards.
Now insert 8 batteries or rechargeable batteries into the
battery compartment. Observe the correct polarity of the
individual cells. The polarity is indicated (3) at the bottom of
the battery compartment.
Then slide the lid of the battery compartment back on from
the bottom until the locking mechanism engages.
c) Charging the Rechargeable Batteries for the Transmitter
For operation with rechargeable batteries you can connect
a charging cable (not included in the supply) to the charging
socket (1) and charge the rechargeable batteries in the
transmitter when the transmitter is switched off.
Always make sure the polarity of the connecting plug is
correct. The inner contact of the charging socket must be
connected to the plus terminal (+) and the outer contact to
the minus terminal (-) of the charger.
The charging current should correspond to approximately
1/10 of the capacity value of the inserted rechargeable
batteries.
42
Figure 3
Figure 4