Reely SKY Tiger Moth Bedienungsanleitung Seite 44

Connect the charger only if rechargeable batteries (1.2V/cell) have been inserted in the transmitter. Never
try to recharge batteries (1.5V/cells) with the charger.
In order to avoid damage to internal printed conductors and connections, please do not use quick chargers.
Because a protective diode is integrated into the transmitter's charging circuit, you cannot use any chargers that briefly
interrupt the charging current to measure the current battery voltage. In this case, remove the rechargeable batteries
from the transmitter for charging.
When new batteries or freshly charged rechargeable batteries have been inserted, switch on the transmitter with the
function switch (see figure 3, item 7) for test purposes. First, the red LED for voltage supply display is lit (see figure 3,
item 12); shortly afterwards, the green LED lights up of the binding function between transmitter and receiver is
performed correctly. Both LEDs thus signal proper transmitter function.
If the power supply is not sufficient for correct transmitter operation anymore (below 8.8 V), a warning sound will occur
at 1.5 second intervals. In this case, you should stop operating your model as quickly as possible.
To continue operating the transmitter, recharge the batteries or insert new batteries.
In order to avoid the memory effect of NiCd rechargeable batteries, you should only recharge them when the re-
chargeable batteries are completely discharged.
44