Operation Of The Helicopter; A) Checking The Rotor Blade Retainer; B) Checking The Centrifugal Weight - Reely SKY I-Helicopter Bedienungsanleitung


10.

Operation of the Helicopter

a) Checking the Rotor Blade Retainers
To allow the four main rotor blades (1) to orient themselves
at a 180° angle to each other during operation, the blade
retainer screws (2) must not be tightened too firmly.
If you pitch the model helicopter to the side by 90°, the rotor
blades must be able to fold downwards on their own as
illustrated in the figure.
Attention!
Do not loosen the fastening screws too much; if
you do, the tracking of the rotor blades will no
longer correspond, and the blade tips will run at
different heights.
Caution!
Only use a suitable screwdriver for tightening
screws and ensure that you do not use excessive
force. The threads or the screw material may be
damaged otherwise.

b) Checking the Centrifugal Weight

The centrifugal weight (1) must be easily movable, just like
the main rotor blades.
Manually move the centrifugal weight up and down on one
side (see arrows in figure 7) and ensure that the two attached
ball joints (2) can be moved easily.
The mechanics must run smoothly, but should not have any
play in their bearings.
Figure 6
Figure 7
33