E) Installing The Tail Unit - Reely SKY Jet Liner Bedienungsanleitung

Put on the impeller ring (1). Make sure that there is no gap.
Wrap the provided silvery adhesive strip from the decal sheet around the ring.
Secure both nacelle parts using the plane identification sticker from the outside
and the white adhesive strip from the inside.

e) Installing the tail unit

Glue the connector (1) for the elevator unit into the rudder (2) using 5-minute
epoxy glue.
Pull the locking pins (3) out of the rudder until they are not visible from the top
any more.
Glue the complete rudder unit (1) upside down to the elevator unit (2) (which is
also upside down) using 5-minute epoxy glue.
Make sure that there is no gap between the components and that an exact 90°
angle is formed.
Before the glue has hardened, insert the locking pins (3) into the rudder unit by
approx. 1 cm to connect the elevator unit.
38
Figure 7c
Figure 8a
Figure 8b