H) Installing The Engine And The Govenor; I) Installation Of The Front And Main Landing Gear - Reely SKY SR-22 Bedienungsanleitung

h) Installing the motor and the govenor
Install the motor with matching screws on the motor frame. Depending on the
type of motor, you may have to adapt the holes and slots in the motor frame.
Depending on the used system, solder or attach the connection wires of the
motor to the wires of the govenor. Attach the govenor with suitable cable clips
or servo tape from the bottom in the front part of the battery slide/servo board.
Note: If the assignment of the wires of the motor and the govenor should not be
clear with the used motor/govenor, we recommend checking the motor rotation
direction prior to soldering or performing any further steps.

i) Installation of the front and main landing gear

Hook the "bent Z" of the approx. 250 mm long connecting rod (1) into the linkage
lever (2). From the outside, slide the nose landing gear wire (3) into the pillow
block (4), insert the linkage lever (2) and slide the nose landing gear wire up to
the top hole of the pillow block.
The angled part of the landing gear wire must point forward. Observe the design
of the linkage lever when installing it. The linkage lever is correctly mounted
when the lever points to the left (seen in flight direction) and the thread for the
attachment screw (5) towards the rear.
Slide the linkage rods of the front landing gear into the rod connection of the
rudder servo (see ill. 8). Set the rudder servo and the front landing gear wire (3)
to neutral. Screw the linkage lever onto the front landing gear wire with an
M3 x 6 screw (5). Also add a drop of screw retainer lacquer on the thread of the
linkage lever.
Mount the two main landing gears onto the wings and secure the wires with 2
latches each, which are then screwed in the wings with 2 x 8 mm screws.
Place the model on the floor and check whether it stands horizontally. If the
fuselage tip points up or down, you have to correct this accordingly on the nose
landing gear.
26
Illustration 9
Illustration 10
Illustration 11