Reely SKY Jet Liner Bedienungsanleitung Seite 37

Install two impellers as shown in figure 6b.
Loosen the straining screw slightly so that you can attach the impeller to the
motor shaft in the next step.
To prevent vibration during operation, it is advisable to balance
the impellers before installing them using a suitable tool!
Put the impeller into the motor shaft and tighten the straining screw.
Make sure that there is a distance of approx. 1 to 1.5 mm between the spinner
back plate and the impeller casing.
Make sure that the impeller can turn freely and does not touch any parts.
Install the engine cowlings as shown in figure 7a & 7b.
The nacelles must be installed close to the impeller casing.
Figure 7a Figure 7b
Figure 6b
Figure 6c
37