D) Installing The Speed Controller; Installing The Receiver; F) Installing The Tail Unit Fin - Reely SKY Space Runner Bedienungsanleitung

d) Installing the speed controller

Connect the speed controller (1) to the motor and attach it to the bottom of the
fuselage behind the battery compartment using double-sided adhesive tape or
servo tape.
A connector system suitable for the flight battery has to be soldered on to the
two power supply cables (2).
The 3-wire control cable (3) has to run below the bottom of the battery where
the receiver will later be installed.
e) Installing the receiver
Once you have checked the function of the connected servos and the speed
controller, attach the receiver (1) in the fuselage with double-sided tape or servo
tape as illustrated.
The aerial wire (2) is installed to the rear to an opening at the end of the fuselage.

f) Installing the tail unit fin

Apply epoxy glue to the bottom of the tail unit fin (1) and put it into the designated
slot (2).
Make sure that the fin is glued on properly aligned at a 90° angle!
20
Illustration 6
Illustration 7
Illustration 8