I) Assembling The Nose Landing Gear - Reely SKY Jet Liner Bedienungsanleitung

Install the rudder arms (1) at a 90° angle to the servos (2). Insert the Bowden
cables (3) into the linkage connectors (4).
Then shorten the linkage with an excess length of approx. 5 mm and secure
the grub screws of the linkage connectors using threadlocker.
When fastening the grub screw, make sure that the respective rudder is in
neutral position.
Glue together the Bowden cables (1) for the elevator and the rudder in the
designated frame (2) using 5-minute epoxy glue.
Gluing protects the Bowden cables from bending and ensures the linkage is
free of play.

i) Assembling the nose landing gear

Form the end of the nose landing gear linkage rod (1) into a "Z".
Our tip: There are special pliers intended for this purpose.
Hook the bent linkage rod into the outermost hole of the steering arm on the
nose landing gear (2).
Figure 10d
Figure 10e
Figure 11a
41