F) Installing The Elevator Linkage; G) Installing The Rudder Linkage - Reely SKY Jet Liner Bedienungsanleitung

Pull the Bowden cables (1) for the elevator linkage out of the fuselage by
15 cm.
Glue the complete tail unit (2) into the provided cut-out in the fuselage (3) using
5-minute epoxy glue.
Make sure that there is no gap between the components and that an exact 90°
angle is formed.

f) Installing the elevator linkage

Press the Bowden cables (1) for the elevator linkage into the provided slot and
secure them with a few drops of superglue.
Connect the Bowden cables to the rudder horns (2) and put a piece of silicon
tube (3) over the connection to secure it.
Then apply the sticker from the decal sheet intended for the linkage.

g) Installing the rudder linkage

Connect the Bowden cable (1) to the rudder horn (2) and put a piece of silicon
tube (3) over the connection to secure it.
Figure 8c
Figure 9a
Figure 9c
39