Installing The Servos - Reely SKY Jet Liner Bedienungsanleitung

h) Installing the servos
Screw the servos into the provided recesses in the servo plate. Drill holes for
the installation screws using a small drill to prevent the servo plate from
splintering.
Install two servo arms as shown in figure 10b & 10c.
Make sure that the linkage connector (1) can be rotated easily but is still installed
tight enough on the servo arm.
Our tip: To prevent the screw connection from getting loose, it is advisable to
secure it with a drop of superglue on the nut (2).
40
Figure 10a
Figure 10b
Figure 10c