Trimming The Model; D) The First Landing; Maintenance And Care - Reely SKY Jet Liner Bedienungsanleitung

c) Trimming the model
If, in straight flight, your model shows the tendency to drift to one direction, correct the neutral position of the corresponding rudder via the trim.
Fly some rounds at a safe height to get used to the steering characteristics of the model.
Caution!
Due to its compact design, you should not let the model fly away too far and also make sure it flies at sufficient speed.

d) The first landing

The first flight should not extend over a long period of time. Try to land the model after a little while. This gives you enough time to make several landing attempts
without exhausting the battery.
Like the first flight, the first landing should always be done against the wind. Reduce the motor speed and fly big and flat circles. Do not pull too hard on the
elevator in order to reduce the flying altitude selectively.
Select the last curve before the landing approach so that you have sufficient room for landing and the course does not have to be changed significantly when
landing. When the model is flying along the planned landing line, reduce the motor speed further or turn off the motor completely, and keep the model in a
horizontal position using the elevator. The model should continue to descend and fly towards the planned touch down point at the end of the imaginary landing
line.
Especially in this critical flying phase, always ensure sufficient flying speed (see "stall" in chapter 11. b) and do not slow down the model too much by reducing
the motor speed too abruptly or by pulling the elevator too hard.
Slightly increase the elevator shortly before touchdown.
After landing, adjust the linkage – if necessary – so that the plane flies straight and the trim levers on the transmitter are in centre position again. Once you are
able to control the airplane perfectly, you can try to optimise flight performance by shifting the centre of gravity.


12. Maintenance and care

Check the linkages and the control functions of the servos on your model regularly. All moving parts have to be easily movable, but should not have any play in
their bearings.
The outside of the model should only be cleaned with a soft, moistened cloth. Never use aggressive cleaning agents or chemical solutions as these may damage
the surfaces.
Important!
If you have to replace damaged or worn parts, use original replacement parts only.
A spare parts list is available on our website at www.conrad.com in the download section of the product.
You can also ask for the spare parts list by phone. For contact information, please refer to chapter "1. Introduction" at the beginning of these
operating instructions.
Damage to foam should only be treated with superglue suitable for hard foam. Conventional superglue can dissolve the foam and damage it severely.
52