C) Resetting The Speed Controller - Reely Big1 Bedienungsanleitung

• Function #5, green LED flashes five times briefly: Maximum brake force
The speed controller offers a proportional brake force depending on the position of the transmitter lever. The maxi-
mum brake force at full deflection is adjustable between 25%, 50%, 75%, and 100%.
A higher setting (e.g. 100%) decreases the braking distance, but has a negative impact on the lifespan of the engine
(especially the drive pinion and main gear).

c) Resetting the speed controller

Use this function to reset all configured settings to the factory defaults (see grey markings in the table in chapter 10. b).
Do the following:
• Switch on the transmitter. Leave the throttle/brake lever in the neutral position, do not move it.
• Turn on the speed controller by moving the slide switch in the direction of the setup button. The vehicle should now
be ready for operation, no LED will light up on the speed controller.
• Press and hold the setup button until the red and green LEDs flash together slowly (the duo colour LED produces
amber light in this case).
• Now turn off the speed controller by setting the slide switch to the "OFF" position; see figure in chapter 10. a) or b).
All settings will then be reset to their default values; see table in chapter 10. b).
Important!
After a reset of the speed controller, you must first program the neutral and full throttle positions, as de-
scribed in chapter 10. a).
You can then change the default settings as described in chapter 10. b), if desired.
51