Resetting The Speed Controller - Reely BASH 6S Bedienungsanleitung

• Function #5, green LED flashes once long: Maximum Brake Force
The speed controller offers a proportional brake force depending on the position of the transmitter lever. The
maximum brake force at full deflection is adjustable between 25%, 50%, 75%, and 100%.
A higher setting (e.g. 100%) decreases the braking distance, but has a negative impact on the lifespan of the engine
(especially the drive pinion and main gear).
c) Resetting the speed controller
Use this function to reset all configured settings to the factory defaults (see grey markings in the table in section 10b).
Proceed as follows:
• Switch on the remote control. Leave the throttle/brake lever in the neutral position, do not move it.
• Turn on the speed controller by moving the slide switch in the direction of the setup button. The vehicle should now
be ready for operation, no LED will light up on the speed controller.
• Hold down the setup button until the red and greed LEDs start to flash.
• Now turn off the speed controller by setting the slide switch to the "OFF" position; see figure in chapter 10. a) or b).
All settings will then be reset to their default values; see table in chapter 10. b).
Important!
After a reset of the speed controller, you must first programme the neutral and full throttle positions, as
described in chapter 10. a).
You can then change the default settings described in chapter 10. b) if desired.
When using LiPo rechargeable batteries to operate the vehicle, make sure that low voltage protection is
enabled (default setting 3.0 V per cell). When low voltage detection is disabled, LiPo rechargeable batteries
are subject to a deep discharge that destroys them.
54