Working With The Mixer - Silvercrest SKM 550 EDS A1 Bedienungsanleitung

Risk of injury from rotating parts!
To avoid personal injury and damage to the appli
ance, NEVER insert or place your hands or foreign
objects into the loading shaft. Only insert
ingredients by use of the stodger.
Only change accessories when the drive motor
is at standstill! After being switched off, the drive motor
j
continues to run for a short time. The appliance
may only be used when the drive openings not
being utilised are covered with drive protection lids.
In cases of malfunction switch the appliance off and
remove the plug from the wall socket, this will avoid
an unintentional switching on of the appliance.
On task completion
• Switch the appliance off with the rotary switch
• Turn the food processor
remove it.
• Disassemble the food processor
parts (see chapter „Cleaning and care").

Working with the mixer

Risk of scalds!
Allow hot fluids to cool to a hand warm temperature
(ca. 30 40°C) before they are poured into the
r
mixer .
Proceed as follows to prepare the appliance for opera
r
tion with the mixer :
• Press the unlocking button
h
swivel arm into operating position 3 (see
chapter „Operating positions").
• Remove the drive protection lid for the mixer
(Fig. ).
r
• Fit the mixer (Marking on the base onto the
marking on the base machine) and turn it
anti clockwise as far as it will go (Fig.
• Fill with ingredients.
Maximum amounts: 1 litre;
foaming liquids, maximum 0,5 litre; optimal
processing amount for solids: 50 100 g
j
g
.
u
anti clockwise and
u
and clean all
f and bring the
).
Note: Take note of the table in the chapter
„Recommended filling quantities".
• Position the lid with funnel and then press it firmly
so that the lid locks into place.
• Set the rotary switch
Risk of injury from sharp knife/rotating
drive!
NEVER reach into the mixer
Remove/put on the knife ONLY when the mixer
is at a standstill! Only use the mixer
firmly in position.
In cases of malfunction switch the appliance off and
remove the plug from the wall socket, this will avoid
an unintentional switching on of the appliance.
Refilling with ingredients
• Turn the appliance off with the rotary switch
• Press the button on the handle of the mixer
(Fig. ), remove the lid and fill with ingredients
or
• rotate the funnel through 90° and remove it.
Gradually insert the solid ingredients through
the refill opening.
or
• refill with fluid ingredients by means of the
trichter.
On task completion
• Switch the appliance off with the rotary switch
• Turn the mixer r
Note: The mixer
after use (see chapter „Cleaning and care").
- 6 -
g
to the desired level.
r when it is in use!
r
with the lid
clockwise and remove it.
r
is best cleaned immediately
r
g
.
r
g
.