Working With The Kneading Hook, Beater And Whisk; Refi Lling With Ingredients - Silvercrest SKM 550 B1 Bedienungsanleitung

Working with the kneading
hook, beater and whisk
WARNING! RISK OF INJURY!
► Under no circumstances should you place
your hands or fi ngers in the mixing bowl 6
during operation! Danger of injury due to
rotating parts!
► Switch from one accessory to another only
when the drive unit z is at a complete
standstill! After being switched off , the drive
unit z will continue to run for a short time.
► In cases of malfunction, switch the appliance
off and remove the plug from the wall socket.
This will prevent the appliance from becoming
switched on again unintentionally.
NOTE
► The appliance may only be used when the
drive hubs not being used are fi tted with their
protective covers.
Proceed as follows to prepare the appliance for
operation using the kneading hook 1, beater 3
and whisk 2:
1) Press down the release button e and move
the pivoting arm t into operating position 4
(see the section "Operating positions") (Image
A).
2) Set the mixing bowl 6 into place. Check that the
base of the mixing bowl 6 is inserted fully into
the recesses u provided for it on the blender.
3) Press down the release button e and move
the pivoting arm t into operating position 1
(Image A).
4) Set the rotary switch r to P and hold it in this
position until the drive unit z settles in its "Park"
position (Image B). If the drive unit z doesn't
move, it is already in its park position (Fig. 2).
5) Press down the release button e and move
the pivoting arm t into operating position 4
(Image A).
SKM 550 B1
All manuals and user guides at all-guides.com
6) If you want to use the kneading hook 1, insert
7) Depending on the task to be performed, insert
8) Add the ingredients you wish to process into
9) Press down the release button e and move
10) Slide the lid onto the mixing bowl 6 so that the
11) Turn the rotary switch r to the required setting.
Refi lling with ingredients
■
Or:
1) Switch the appliance off using the rotary
2) Set the rotary switch r to P and hold it in
3) Remove the lid.
4) Press down the release button e and move
5) Add the ingredients.
the dough defl ector into the drive unit z
(Image D). Ensure that the hole through which
the kneading hook is inserted is lying over the
mounting hole on the drive unit z.
the kneading hook 1, beater 3 or whisk 2 so
that they fi rmly click fi rmly into the drive unit z.
the mixing bowl 6.
NOTE
► While kneading and/or mixing, please note
that the dough in the mixing bowl 6 will in-
crease in volume or will be pressed upwards
by the tool. Take note of the table in the sec-
tion "Recommended fi lling quantities".
the pivoting arm t down into operating
position 1 (Image A).
catches on the pivoting arm t click into place.
Add the ingredients through the hole in the lid
during operation.
switch r.
this position until the drive unit z comes to a
standstill (Image B).
the pivoting arm t into operating position 5.
GB
7