Herunterladen Diese Seite drucken

HYVA HC101 Bedienungsanleitung Seite 51

Werbung

- Non toccare o avvicinarsi alla
prossimità
del
tamburo
puleggia.
- Utilizzare sempre elmetto, scarpe
antinfortunistiche, guanti da lavoro.
Evitare di indossare indumenti con
facili appigli. Si consiglia pertanto
far
uso
di
una
tuta
abbottonata
e
senza
volanti.
- Durante il lavoro non toccare e
avvi
cinarsi agli organ
i in movimento
del
verricello (tambu
ro, pressacavo,
ecc.).
- Prima di iniziare il lavoro è fatto
obbligo
verificare
attenzione l'integrità della redancia,
della tasca e della fune. Le più
frequenti cause di danneggiamento
della fune sono:
 lo scarrucolamento e lo sfregamento
contro parti in movimento (1)
 lo scorrimento su pulegge lo
la deformazione plastica dovuta a
schiacciamento (3)
 l'eccessivo attorcigliamento (4).
1
fune in
- Do NOT approach or touch the rope
e
de
lla
near the drum or pulley.
- Always wear a helmet, industrial
footwear and gloves. Do NOT wear
loose or baggy clothing. Perso
di
must wear overalls secured using
da
lavor
o
buttons and without loose or baggy
appendici
parts.
- During operation do NOT approach or
touc
h the moving
(dru
m, rope press,
- Before starting work carefully check
con
molta
the integrity of the thimble, pocket and
rope. The most frequent cause of
damage to the rope are as follows:
 rubbing against moving parts (1)
running over worn pulleys (2)
gorate (2)
 deformation of plastic
excessive twisting (4)
2
nnel
parts on the winch
etc.).
due to crushin
g (3)
3
A-42
- Das Seil nicht berühren und ni
die Nähe der Trommel und
Seilscheibe kommen.
- Immer
Schutzhelm,
schuhe
und
Arbeitshandschuhe
tragen. Keine Kleidung tragen, die
leicht
hängen
bleiben
empfiehlt
sich
daher,
zugeknöpften
Arbeitsoverall
flatternde Teile zu tragen.
- Während
der
Arbeit
bew
eglichen
Teile
(Tro
mmel,
Kabelkl
emme
berühren und nicht in ihre Nähe
kommen.
- Vor Beginn der Arbeit muss die
Unversehrtheit
der
Kausche,
Tasche
und
des
Seils
kontrolliert werden. Die häufigsten
Ursachen für die Beschädigung des
Seiles sind:
 Entgleisen des Seiles und Reiben
gegen in Bewegung befindliche Teile (1)
 Laufen auf abgenutzten Seilscheiben (2)
 plastische
Verformung durch Einquet-
schen (3)
 übermäßige Verdrehung (4).
4
cht in
der
Sicherheits-
kann.
Es
einen
ohne
nicht
die
der
Wi
nde
usw.)
der
genau

Werbung

loading