Key Assignment; Live Image Display In Monitor Lock Mode - Siemens CKA4820 V2 Benutzerhandbuch

Configuration of SIMATRIX

11.2.4 Key assignment

11.2.5 Live image display in monitor lock mode

54
Siemens Building Technologies
Fire Safety & Security Products
In operating mode Control unit connected to SIMATRIX RS232 interface, the
keys F1 to F10 are configured in the video matrix.
To select the telemetry devices and monitors, enter the key sequence as shown in
the following table. You must start again if you do not press the next key within
three seconds.
Example:
Key sequence
In monitor lock mode you can select the monitor on which the live image of a
particular camera is to be displayed.
Prerequisite:
The monitor lock mode is switched on. See Section 10.4.4: Changing the
–
joystick mode .
1. Select a monitor.
Key sequence
2. Enter the input number.
3. Press the Cam key.
Key sequence
The corresponding live image is displayed on the selected monitor.
The following configurations support the monitor lock mode:
SIMATRIX TTY
SIMATRIX RS232
Molynx-D
Description
Select dome/camera 5 on monitor 1
Description
Selection monitor 1
Description
Switch dome/camera 5 to the selected
monitor
03.2009