Meaning Of Led Displays; Change Pin Code; Pin Code Entry; Change User - Siemens CKA4820 V2 Benutzerhandbuch

Setup
9.3

Meaning of LED displays

9.4

Change PIN code

40
Siemens Building Technologies
Fire Safety & Security Products
3. Press the key switch.
The code input is accepted.
The LCD indicates:
CKA4820 status: Admin login
or
CKA4820 status: User login
If the message Cal is additionally output on the LCD, the joystick is not calibrated.
Calibrate the joystick. See Section 19.1: Joystick calibration.
In operating mode Telemetry devices connected directly to control unit, the
LED always lights up green.
In mode Control unit connected to SIMATRIX terminal/TTY connection, the
LED displays three possible statuses:
LED lights up green: connection is made to the video matrix, and data is being
received.
LED flashes red: no connection made to video matrix.
LED lights up red: alarm signal from video matrix.
Prerequisite:
You are logged in as administrator in CKA4820 status: Admin login. See Section

9.2: PIN code entry.

1. Keep MON key pressed, press F1 key.
The LCD indicates:
Parameter menu
Base parameters
The LED flashes in orange.
2. Move joystick downwards until the LCD displays the following:
Parameter menu
Change PIN codes!
3. Move joystick to right until the LCD displays the following:
Change PIN codes!
Change Administrator
If you wish to change the PIN code for User1: move joystick up or down until
the LCD displays the following:
Change PIN codes!
Change User
4. Move joystick to right to change.
The LCD indicates:
PIN code input
PIN code: xxxx|xxxx|xxxx
03.2009