14
Configuring SISTORE MX
14.1
Connection to COM1B
14.1.1 Selecting control unit interface COM1
Siemens Building Technologies
Fire Safety & Security Products
Prerequisites:
The SISTORE MX is connected.
–
See Section 8.5: Connecting SISTORE MX.
The control unit has been put into service.
–
See Section 9.1: Control unit setup.
Software version 2.60 or higher is installed on the device.
–
The interface settings are identical for all devices.
–
Fig. 35
Control unit connected to SISTORE AX via RS232/RS485 interface
(COM1A/B)
To select the control unit interface COM1 use the following key combination on the
control unit.
Key sequence
Description
1. Keep POS key depressed.
2. Press key 1 (COM1).
Configuring SISTORE MX
03.2009
61