10.4.3 Changing interface settings
10.4.4 Changing the joystick mode
10.4.5 Change PIN code
10.4.6 Key disabling
10.4.7 Calibrating and testing the joystick
Siemens Building Technologies
Fire Safety & Security Products
Prerequisite:
You have opened the Base parameters/Interface adjustment menu. See Section
10.4.1: Open parameter menu/Base parameters.
Interface settings
Mode COM1
Protocol COM2
Prerequisite:
You have opened the Base parameters/Interface adjustment menu. See Section
10.4.1: Open parameter menu/Base parameters.
Interface settings
Joystick mode
Monitor lock mode
Prerequisite:
You have opened the Base parameters / Interface adjustment menu. See
Section 10.4.1: Open parameter menu/Base parameters.
Change PIN codes
Administrator
User1
Key disabling
"Mem" key
Maintenance assistance
Joystick calibration
Joystick test
Description
Setting of operating mode.
See Sections 11 to 14.
Setting of protocol used.
See Sections 11 to 14.
Description
Switching between variable - telemetry devices are controlled with
variable speed - and fixed - fixed motion speed of telemetry
devices.
Switching the monitor lock mode feature on and off.
Description
Change PIN code for administrator. Administrator login required.
See Section 9.4: Change PIN code.
Change PIN code for users. Administrator login required.
See Section 9.4: Change PIN code.
Description
If key disabling is set to "Disable", pressing the "Mem" key does not
trigger a function.
Administrator login required.
Description
Calibration of joystick.
See Section 19.1: Joystick calibration
Function test of joystick. When moving in one direction, the LCD
displays the corresponding X, Y or Z coordinate until the function is
exited using F10.
Configuration
47
03.2009