Configuring IVM Terminal Client
13
Configuring IVM Terminal Client
58
Siemens Building Technologies
Fire Safety & Security Products
Prerequisites:
The IVM Terminal Client is connected to the control unit interface COM1A. See
–
Section 8.4: Connecting an IVM Terminal Client.
The control unit has been put into service. See Section 9.1: Control unit setup.
–
Fig. 34
Control unit connected to IVM Terminal Client via RS232 interface
(COM-X)
The telemetry devices to be controlled are connected to the TTY interface of the
video matrix (Fig. 32).
Each time a key is pressed, the telegrams are sent to the connected devices via
the control unit and telemetry interfaces. Ensure that the settings on the control unit
are correct.
03.2009