Siemens simovert masterdrives Betriebsanleitung Seite 241

05.2006
Some parameters may also be displayed without a parameter number,
e.g. during quick parameterization or if "Fixed setting" is selected. In
this case, parameterization is carried out via various sub-menus.
Example of how to proceed for a parameter reset.
Selection of fixed setting
Selection of factory setting
Start of factory setting
NOTE
It is not possible to start the parameter reset in the "Run" status.
Siemens AG 6SE7087-6JK50
SIMOVERT MASTERDRIVES
P
0.0 A 0 V 00 MotionControl
# 0.00 min-1 *Menu selection
* 0.00 min-1 OP: Upread
Ready OP: Download
∇
P
Fixed Setting Fixed Setting
*Select FactSet *Select FactSet
FactSet. #FactSet.
wait
P
Factory Setting Menu Selection
#FactSet. *User Param..
*No FactSet Param. Menu..
busy............ FixedSet...
Operating Instructions
2 x
∇
P
Menu Selection Menu Selection
*User Param. *User Param.
Param Menu.. Param Menu..
Fixed Set... #Fixed Set...
P
Factory Setting Factory Setting
FactSet. #FactSet.
*No FactSet *No FactSet
Parameterization
8-13