Resetting An Emergency Stop Situation; Power Failure, Restoring Readiness For Operation; Speed Setting; Feed Speed - Optimum OPTImill MH 25 SV Betriebsanleitung

CAUTION!
The emergency stop mushroom button may only be activated in an emergency. A normal
shut-down of the machine must not be executed using the emergency stop mushroom
button.
4.5

Resetting an emergency stop situation


Unlock the emergency stop mushroom button again.

Move the axis direction switches to the neutral middle position.

Switch the control on again.

Switch on the spindle rotation again.
4.6

Power failure, Restoring readiness for operation


Move the axis direction switches to the neutral middle position.

Switch the control on again.

Switch on the spindle rotation again.
4.7

Speed setting

The adjustment of the speed in the range from 200 - 4000 min
the rotary knob on the control panel.
4.8

Feed speed

Adjust the feed speed for each axis with the rotary knob. The
adjacent illustration shows the approximate automatic feed
speed in metres per minute.

4.8.1 Resetting the automatic feed

Reset key
To free an axis when the axis has traveled to the end position.

Press and hold the reset button and press either the direction switch or the rapid feed but-
ton for the respective axis to move it away from the end position switch.
Version 1.0.1 dated 2015-12-17
-1
is continuously variable with
0.15
0.1
0.08
Img.4-1:
Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
0.39
0.93
m/min
0.24
0.58
m/min
0.19
0.45
m/min
Feed speed
MH25SV GB
Page 75