Unpacking And Connecting; Scope Of Delivery; Transport; Installation And Assembly - Optimum Optimill Mh 25 Sv Betriebsanleitung

OPTIMUM
M A S C H I N E N - G E R M A N Y
3

Unpacking and connecting

INFORMATION
The milling machine is pre-assembled.
3.1

Scope of delivery

Check immediately upon delivery of the milling machine if there are any transport damages or
loosened fastening screws.
Compare the scope of delivery with the attached packing list.
3.2

Transport

Centres of gravity

Load suspension points

(Marking of the positions for the load suspension
gear)
Prescribed transportation position

(Marking of the top surface)
Means of transport to be used

Weights

WARNING!
Severe or fatal injuries may occur if parts of the machine tumble or fall down from the
forklift truck or from the transport vehicle. Follow the instructions and information on
the transport box.
WARNING!
The use of unstable lifting and load suspension equipment that might break under load
may cause severe injuries or even death. Check that the lifting and load suspension gear
has sufficient load capacity and that it is in perfect condition. Observe the accident
prevention regulations issued by your Employers Liability Insurance Association or
other supervisory authorities responsible for your company. Fasten the loads properly.
Never walk under suspended loads!
3.3

Installation and assembly

3.3.1 Requirements regarding the installation site

The working area for operating, maintenance and repair must not be hindered.
The milling machine's power plug must be readily accessible.
The illumination of the working place has to be such that an intensity of illumination of 500 Lux
is attained at the tool tip.
If this is not ensured with normal illumination at the installation location, an additional lamp must
be installed at the workplace.
GB MH25SV
Page 68 Original operating instructions Version 1.0.1 dated 2015-12-17