Parameter Setting Of X Y Z-Axis And Speed Axis; Parameter Setting Of X-Axis - Optimum OPTImill MH 25 SV Betriebsanleitung

5.4.2 Parameter setting of X Y Z-axis and speed axis

X-axis parameter
Three-level menu, press the "PROG" key to enter to modify the X-axis parameter.
Y-axis parameter
Three-level menu, press "PROG" key to enter and modify the Y-axis parameter.
Z-axis parameter
Three-level menu, press "PROG" key to enter to modify the Z-axis parameter.
Speed axis parameter
Three-level menu, press "PROG" key to enter to modify the speed axis parameter.
Exit
Press "PROG" key to return to the main menu.

5.4.3 Parameter setting of X-axis

Sensor
Setting of sensor type: Press "PROG" to enter the menu, the digital sensor types MS100,MS200,MS500
are selectable.
Setting resolution
Press "PROG" key to enter and choose.
For sensor type MS 100, there are 5 options: 1µm
For sensor type MS 200, there are 4 options: 2µm
For sensor type MS 500, there are 3 options: 5µm
Setting counting direction
Press the "PROG" key to enter the menu. "+/-" as a select.
Setting display mode
Press the "PROG" key to enter the menu. "On / Off" as a select.
Linear error compensation
Press the "PROG" key to enter the menu, use the ↑ ↓ ← → keys to modify, then press the "PROG" key to
exit.
Save and Exit
Saving new parameters, press the "PROG" key to confirm, then return to section 5.4.2.
Exit
When the new parameter setting is invalid, press the "PROG" key to confirm, then return to section 5.4.2
INFORMATION
The parameter setting of the Y-axis and the Z-axis is the same as for the X-axis.
Version 1.0.1 dated 2015-12-17
ǀ ǀ ǀ ǀ
2µm 5µm 10µm 50µm
ǀ ǀ ǀ
5µm 10µm 50µm
ǀ ǀ
10µm 50µm
Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
DRO5 GB
Page 83