Automatic Feed Of An Axis; Rapid Feed; Insert Tool; Quick-Change Clamping System - Optimum OPTImill MH 25 SV Betriebsanleitung

OPTIMUM
M A S C H I N E N - G E R M A N Y
4.8.2

Automatic feed of an axis


Set the direction switch to the desired direction.

Set the feed speed.

4.8.3 Rapid feed


Set the feed speed to maximum.

Press the rapid feed button for the respective axis and hold.
4.9

Insert tool

4.9.1 Quick-change clamping system

The milling head is equipped with a collet chuck for tigh-
tening with pull stud BT30x45 °.

Tightening the pull stud into the taper.

Clean the seat in the milling spindle.

Clean the cone of your tool.

Place the tool into the milling spindle. Put a 10mm
Allen key in the mounting hole and turn it clockwise
to open the collet chuck.

4.9.2 Removal


Hold the tool.

Put a 10mm Allen key in the mounting hole and turn
it clockwise to open the collet chuck.
GB MH25SV
Page 76
Img.4-2:
Img.4-3:
Original operating instructions
43
23
45°
pull stud
MAS BT30
Version 1.0.1 dated 2015-12-17