The Main Menu; Lcd Display Parameter Setting - Optimum OPTImill MH 25 SV Betriebsanleitung

OPTIMUM
M A S C H I N E N - G E R M A N Y
5.4

The main menu

In the normal display state, press and hold the "PROG" key for three seconds to enter the main menu.
LCD display setting
LCD display setting: the secondary menu, press "PROG" key to enter to modify the LED display parame-
ter.
Unit selection
Press the "PROG" key to select mm/inch.
Language selection
Press "PROG" key to select English/German.
Working mode
Press the "PROG" key to select
 X Y Z - for use on milling machines
 2X Z+Z0 - for use on lathes, turning diameter, added bed slide + top slide.
 2X Z0 Z - for use on lathes, turning diameter, bed slide and top slide separately.
for selection.
Decimal point
Decimal place setting. Selection of 2 or 3 decimal places.
Channel setup
Multilevel menus, press the "PROG" key to enter the menu, to modify X Y Z as well as the speed axial
parameter.
Operation
Introduction of the main functions.
Save and Exit
To save new parameters, press the "PROG" key to confirm and return to the normal display state.
Exit
If the new parameter setting is invalid, press the "PROG" key to confirm, then return to the normal display
state.

5.4.1 LCD display parameter setting

Contrast
Press the "PROG" key to enter the menu, selection range is 0~31, the increment or decrement is 1.
Lighting
Press the "PROG" key to enter the menu, selection range is 0~63, the increment or decrement is 1.
Test sample
Selection of three different RGB display types.
Press the "PROG" key to enter the menu, selection range is 0~3, the increment or decrement is 1.
Save and Exit
Saving new parameters, press "PROG" key to confirm, then return to the main menu.
Exit
New parameter setting is invalid, press "PROG" key to confirm, then return to the main menu.
GB DRO5
Page 82 Original operating instructions Version 1.0.1 dated 2015-12-17