For Your Own Safety During Operation; Switching-Off And Securing The Milling Machine; Using Lifting Equipment; Icons On The Milling Machine - Optimum OPTImill MH 25 SV Betriebsanleitung

1.12

For your own safety during operation

WARNING!
Before you activate the milling machine, ensure that it will neither endanger other
persons nor cause damage to equipment.
Avoid any unsafe work methods:
Make sure that no one is endangered by your work.
The instructions described in these operating instructions must be strictly observed during

assembly, operation, maintenance and repair.
Wear safety goggles.

Switch off the milling machine before you measure the workpiece.

If your concentration is reduced, for example, due to medications, do not work on the milling

machine.
Remain next to the milling machine until all movement is completely stopped.

Use the prescribed personal protective equipment. Be sure to wear close-fitting clothing

and, if necessary, a hairnet.
Do not wear gloves while drilling or milling.

Disconnect the safety plug from the outlet before changing tools.

Use appropriate equipment to remove drilling and milling chips.

Make sure that your work does not endanger anyone.

Safely and firmly clamp the workpiece before switching on the milling machine.

For the specific dangers when working with and at the milling machine, we provide descriptions
about specific dangers for these types of work.
1.13

Switching-off and securing the milling machine

Disconnect the mains plug before starting maintenance and repairs.
1.14

Using lifting equipment

WARNING!
The use of unstable lifting and load suspension equipment that might break under load
may cause severe injuries or even death.
Check to ensure that the lifting and load-suspension equipment are of sufficient load-
bearing capability and are in perfect condition.
Observe the accident prevention regulations issued by your Employers Liability
Insurance Association or other supervisory authorities responsible for your company.
Fasten the loads properly.
Never walk under suspended loads!
1.15

Icons on the milling machine

Make sure that the command and warning symbols are legible.
Version 1.0.1 dated 2015-12-17 Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
MH25SV GB
Page 63