Appendix; Copyright; Terminology/Glossary; Change Information Operating Manual - Optimum OPTImill MH 25 SV Betriebsanleitung

OPTIMUM
M A S C H I N E N - G E R M A N Y
8

Appendix

8.1

Copyright

This document is protected by copyright. All derived rights are reserved, especially those of
translation, re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar
means and recording in data processing systems, either partial or total.
Subject to technical changes without notice.
8.2

Terminology/Glossary

Term
Cross table
Taper mandrel
Workpiece
Drawbar
Drill chuck
Collet
Drill-mill head
Quill
Milling spindle
Drilling table
Taper mandrel
Quill lever
Quick action - drill chuck
Workpiece
Tool
Emergency stop
Emergency switching off
8.3

Change information operating manual

Chapter
2 , 4 , 6
GB MH25SV
Page 92
Explanation
Bearing surface, clamping surface for the workpiece with X-axis and Y-
axis travel
Cone of the tool holder, cone of the drill or of the drill chuck
piece to be milled, drilled or machined.
Threaded rod to fix the taper mandrel in the quill.
Drill bit adapter
Holder for end mill
Upper part of the milling machine
Hollow shaft in which the milling spindle turns.
Shaft activated by the motor
Supporting surface, clamping surface
Cone of the drill or of the drill chuck
Manual operation for the drill feed
Drill chuck can be fixed by hand.
Piece to be drilled or machined.
Milling cutter, drill bit, etc.
Stops the operation of a machine.
Interrupts the power supply of the machine.
Short summary
Drawbar replaced with quick tool system BT30
Original operating instructions
new version number
1.0.1
Version 1.0.1 dated 2015-12-17