Safety; Type Plate - Optimum OPTImill MH 25 SV Betriebsanleitung

1

Safety

Glossary of symbols
provides further instructions


calls on you to act
enumerations

This part of the operating instructions
explains the meaning and use of the warning notes included in these operating instructions,

defines the intended use of the milling machine,

points out the dangers that might arise for you or others if these instructions are not

observed,
informs you about how to avoid dangers.

In addition to these operation instructions, please observe
the applicable laws and regulations,

the statutory provisions for accident prevention,

the prohibition, warning and mandatory signs as well as the warning notes on the milling

machine.
When installing, operating, maintaining and repairing the milling machine, it is necessary to
observe the corresponding standards.
If European standards have not yet been incorporated in the national legislation of the country
of destination, the specific applicable regulations of each country must be observed.
If required it is necessary to take the corresponding measures to comply with the country-spe-
cific regulations before putting the milling machine into operation.
Always keep this documentation near the milling machine.
If you would like to order another operating manual for your machine, please indicate the serial
number of your machine. The serial number is located on the type plate.
1.1

Type plate

Version 1.0.1 dated 2015-12-17 Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
MH25SV GB
Page 53