Qualification Of Personnel; Target Group - Optimum OPTImill MH 25 SV Betriebsanleitung

OPTIMUM
M A S C H I N E N - G E R M A N Y
As the operating company, this is your responsibility!

"Safety devices" on page 60
1.6

Qualification of personnel

1.6.1 Target group

This manual is addressed to
the operating companies,

the operators,

the maintenance personnel.

Therefore, the warning notes refer to both the operation and maintenance of the milling
machine.
WARNING!
Disconnect the milling machine always from the electrical power supply. This will prevent it from
being used by unauthorized persons. The qualifications of the personnel for the different tasks
are mentioned below:
Operator
The operator is instructed by the operating company about the assigned tasks and possible
risks in case of improper behaviour. Any tasks performed beyond operation in standard mode
may only be performed by an operator if they are described in these instructions and if the oper-
ator has been specifically trained to perform them by the operating company.
Electrical specialist
Due to their professional training, knowledge and experience as well as knowledge of respec-
tive standards and regulations, qualified electricians are able to perform work on the electrical
system and recognise and avoid any possible dangers. Qualified electricians have been spe-
cially trained for the working environment, in which they are working and know the relevant
standards and regulations.
Qualified personnel
Due to their professional training, knowledge and experience as well as knowledge of relevant
regulations, qualified personnel are able to perform the assigned tasks and to independently
recognise and avoid any possible dangers.
Trained person
Trained persons have been instructed by the operating company regarding the assigned tasks
and any possible risks of improper behaviour.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must
be duly qualified,

and strictly follow these operating instructions.

In the event of improper use
there may be a risk to personnel,

there may be a risk to the milling machine and other material values,

the correct function of the milling machine may be affected.

GB MH25SV
Page 58 Original operating instructions Version 1.0.1 dated 2015-12-17