all safety regulations relevant to the machine,
its operation and
generally accepted engineering standards.
The operator must also
check the personnel's knowledge level,
document the training/instruction,
have attendance at the training/instruction confirmed by signature and
check whether personnel is working in a manner that shows awareness of safety and risks.
Define and document the machine inspection deadlines in accordance with section 3 of the
Factory Safety Order and perform an operational risk analysis in accordance with section 6
of the Safety at Work Act.
1.6.4
User's obligations
The user must
have read and understood the operating instructions,
be familiar with all safety devices and regulations and
be able to operate the machine.
1.6.5
Additional requirements regarding qualification
The following additional requirements apply for work on electrical components or equipment:
They must only be performed by a qualified electrician or person working under the instruc-
tions and supervision of a qualified electrician.
Before starting work on electrical parts or operating agents, the following actions must be taken
in the order given:
disconnect all poles,
secure against restarting,
check that there is no voltage.
1.7
User positions
The user position is in front of the drilling-
milling machine.
1.8
Safety measures during operation
CAUTION!
Danger due to inhaling dust and mist that are hazardous to health.
Depending on the materials to be machined and the agents used, dusts and mists can
arise that are detrimental to health.
EN
MB4
54
Translation of original instruction
Img.1-1:
User positions
Version 1.0.1 - 2021-11-18