Qualification Of Personnel; Target Group - Optimum OPTidrill DH 40CT Betriebsanleitung

INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must

be duly qualified

and strictly follow these operating instructions.
In the event of improper use

there may be a risk to personnel,

there may be a risk to the machine and other material values,

the correct function of the drilling milling machine may be affected.
Always disconnect the drilling and milling machine machine when cleaning or maintenance
work is being carried out.
WARNING!
The drilling milling machine may only be operated with functional safety devices.
Disconnect the drilling milling machine immediately, whenever you detect a failure in the
safety devices or when they are not fitted!
All additional devices installed by the operator must be equipped with the stipulated
safety devices.
This is your responsibility being the operator!
1.6

Qualification of personnel

1.6.1

Target group

This manual is addressed to

the operating companies,

the operators,

the maintenance personnel.
Consequently, the warning notes refer both to the use of the drilling milling machine and to its
maintenance.
Determine clearly and explicitly who will be responsible for the different activities on the
machine (operation, maintenance and repair).
Unclear responsibilities constitute a safety risk!
Always lock the main switch after switching off the drilling milling machine. This will prevent it
from being used by unauthorized persons.
INFORMATION
Unclear responsibilities constitute a safety risk!
The qualifications of the personnel for the different tasks are mentioned below:
Operator
The operator has been instructed by the operating company regarding the assigned tasks and
possible risks in case of improper behaviour. Any tasks which need to be performed beyond the
operation in standard mode must only be performed by the operator, if so indicated in these
instructions and if the operator has been expressively commissioned by the operating company.
Qualified electrician
With professional training, knowledge and experience as well as knowledge of respective
standards and regulations, qualified electricians are able to perform work on the electrical sys-
tem and recognise and avoid any possible dangers.
Qualified electricians have been specially trained for the working environment, in which they are
working and know the relevant standards and regulations.
Safety
Version 1.0.1 - 2021-07-06

Safety devices on page 61
Translation of original instruction
DH 40CT EN
59