Basic Functions; Adjusting The Back Angle - Ottobock Lisa Gebrauchsanweisung

CAUTION
Failure to check for proper functioning
Falling, tipping over of the user due to lack of maintenance
► In the interest of the user's safety, check the product for correct function before each use.
► Please also read the instructions in the section "Maintenance" > "Maintenance intervals".
CAUTION
Uncontrolled driving behaviour, unexpected sounds
Falling, tipping, collision with people or nearby objects due to defects
► If any faults, defects or other hazards that can lead to personal injury are detected, the product must be taken
out of service immediately. This includes uncontrolled (driving) movements as well as sounds that are unex­
pected or previously not noted or odours that deviate significantly from the state of the product at the time of
delivery.
► Please contact your authorised dealer.
INFORMATION
Please also observe the safety instructions in the section "Safety" > "Safety instructions for use".

6.2 Basic functions

6.2.1 Adjusting the back angle

1) Engage the wheel lock (see Page 50).
2) Secure the back support with one hand (see fig. 10).
3) Pull the release cord a few centimetres upwards (see fig. 10) to release the angle adjustment of the back sup­
port (see fig. 11, item 1).
4) Move the back support to the desired angle while keeping the release cord pulled (see fig. 12, see fig. 13).
5) Let go of the release cord again so that the bars on the left and right side lock into place (see fig. 11).
CAUTION! Check that the lock is firmly engaged by pulling on the back support.
10
12
Lisa
11
13
Use
49