Warning Symbols And Nameplates; Further Information - Ottobock M1 Intro Gebrauchsanweisung

NOTICE
Damage caused by wear and tear. If the upholstery gets worn or damaged, replace it immediately.
With new seat upholstery, you will automatically receive new lamellar plugs for the seat tube which you
should use to replace the previously installed old lamellar plugs.
NOTICE
Risk of damage caused by incorrect packaging. Only use original packaging for shipment of the
product.

2.3 Warning symbols and nameplates

Label

2.4 Further information

INFORMATION
Even in the event of compliance with all applicable guidelines and standards, alarm systems (e.g. in
department stores) may respond to your product. Should this happen, remove your product from the
area where the alarm was triggered.
M1 Intro · M2 Effect · M3 Hemi · M4 XXL · M5 Comfort · M6 Junior · Asia
A Type designation
B Article number of the manufacturer
C Maximum load capacity
(see section "Technical Data")
D Manufacturer information / address
E Serial number
F International article number
G Read the instructions for use prior to using
the product.
H CE symbol – product safety according to
EU guidelines
I Only Start M4 XXL: The product has not been ap-
proved by the manufacturer for use as a seat in a
wheelchair accessible vehicle.
Depending on the nameplate version: The product has
not been approved by the manufacturer for use as a seat
in a wheelchair accessible vehicle.
Attention!
Read the Instructions for Use prior to using the product.
Safety instructions
Meaning
Ottobock | 55