Changing The Unit Of Measurement; Push-Button - Beta ALP 4.0 Bedienungsanleitung

5.1 Changing the unit of measurement

Only the symbols Km/h and mph will be
displayed, and the unit selected will be shown
fl ashing (with f=1Hz, Duty=50%) (fi g. 16).
A short press of the button will cause the
selected unit to change while a long press
permits switching to the next adjustment or
exiting the Set-up menu.

6. PUSH-BUTTON

The purpose of the button is to:
- allow for scrolling through the various functions.
- reset the partial distance and maximum speed values and enable the chronometer.
- access the Set-Up menu.
- adjust the clock.
Scrolling through the functions (i.e. the passage from one function to the next) is always
permitted, regardless of the state of motion or rest of the vehicle; simply press the button
briefl y (tmin = 1 sec.) and, once released, the display will updated with the new function.
The partial distance and the maximum speed can be reset when the vehicle is stopped
or moving, as described in the previous paragraphs.
Entry into the Set-Up menu, clock adjustment and chronometer activation is only allowed
when the vehicle is stopped and operated as described in chapters 2 and 6.
The button is active when the key switch is set to the ON position.
6.1 Sequence of functions represented
It is always possible to scroll through the functions, whether the vehicle is stationary or
moving, using the button according to the sequence shown in the table below:
Fig. 16
TOTAL
TD
LAP
MAX
STDBY
105
total distance covered
partial distance covered
lap time
maximum speed
clock adjustment
1
GB