Alarm Management - Beta ALP 4.0 Bedienungsanleitung

1
In this case, during adjustment, AM will
appear on digits 10 and 11 or PM will
appear on digits 11 and 12 as shown
in fi gure 14.
Note: While the Set-up menu is
open the clock is NOT updated.
Note: Once in the adjustment
menu:
- if 20 sec. go by without the
button being pressed, or
- if the vehicle is started (spe-
ed>0), or
- if the key switch is set to the
OFF position,
Fig. 14
the system will automatically
be set to the standard operating
mode, saving any changes that
have been made.

3. ALARM MANAGEMENT

3.1. Battery voltage alarm
Every time the detected voltage value
falls below 10.0 V (±0.2 V), the system
activates the alarm procedure to signal
that the dashboard may lose its settings,
following the vehicle's start-up.
The signalling causes the battery symbol
and the outline of the digital bar graph to
Fig. 15
fl ash as shown in fi g. 15.
The alarm stops when the voltage rises
above 11.0 V (± 0.2 V).
GB
103