Beta ALP 4.0 Bedienungsanleitung Seite 100

1
If the speed is >0, the LAP function cannot be accessed: pressing the button causes the
function displayed to change.
If the speed is >0, it is not possible to exit the LAP function: pressing the button causes
the value indicated to be reset (if the button is pressed for more than 5 seconds).
The datum is not stored permanently.
If the datum is higher than 23-59 (that is, 23h59'59"), the system resets the LAP and
then restarts the count.
Note: In the absence of mains power, the LAP value is irretrievably lost.
Fig. 9
GB
2.5 Maximum speed (MAX)
This function describes the operation/
display of the maximum speed function.
The information is displayed using digits
2-5 and the abbreviation MAX, as shown
in fi g.9.
The parameter identifi es the vehicle's
maximum speed reached, expressed in
Km/h or in mph, depending on the unit
of measurement selected.
The counter linked to this parameter can
be reset by pressing the button, near the
MAX function, for approx. 2 seconds, until
the value 00 appears.
MAX can be reset when the vehicle is
stopped or moving.
The value is reset when the unit of measu-
rement is changed.
The datum is not stored permanently.
Note: In the absence of mains
power, the MAX value is irretri-
evably lost.
100