Chronometer (Lap) - Beta ALP 4.0 Bedienungsanleitung

2.4 Chronometer (LAP)

This function describes the operation/display
of the chronometer.
The information is displayed using digits 1-5
and the abbreviation LAP.
To access the chronometer menu, press and
hold down the button that corresponds to
the screen, as shown in fi gure 6, until the
chronometer appears (fi gures 7-8).
The time is displayed in the format mm:ss se
hours = 0 or in the format hh:mm se hours >0
If hours >0, when LAP is operational, the
symbol - that separates the hours from the
minutes, is fl ashing; when LAP is not opera-
tional, the symbol is continuous.
If hours = 0, when LAP is operational, the
"e" symbols that separate the minutes from
the minutes, are shown fl ashing; when LAP
is not operational they are continuous.
Start-up: the chronometer can be started in
two ways:
1) manually, by pressing the button briefl y
(<2 sec);
2) automatically, if the speed becomes >0
Deactivation: the chronometer can be stopped
in the following way:
1) automatically, if the speed is = 0
If the speed is = 0, the chronometer stops,
even if it has been activated using the button.
Resetting: The chronometer can be reset by
pressing and holding down the button (>
5 sec).
Exit: to exit chronometer mode, press and
hold down the button for approx. 2 to 5
seconds with speed=0.
If the chronometer is operating at the mo-
ment of exiting, the abbreviation LAP will be
shown fl ashing, independently of the function
displayed.
Fig. 6
Fig. 7
Fig. 8
99
1
GB