Herunterladen Inhalt Inhalt Diese Seite drucken

Beta ALP 4.0 Bedienungsanleitung Seite 98

Vorschau ausblenden Andere Handbücher für ALP 4.0:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

1
The information is always calculated in Km,
but when displayed it may be expressed in
Km (the default value) or in miles.
The unit of measurement can be changed
from the Set-Up Menu.
It is not possible to reset such information du-
ring conditions of normal use of the instrument.
2.3 Partial distance (TD)
This function describes the operation/display
of the onboard automatic partial totalizator.
This function is always shown using digits 1-5
and the abbreviation TD (fi g. 5).
The datum displayed represents the distance
covered by the vehicle, expressed in miles or
Fig. 5
Km (depending on the unit of measurement
selected), with 0.1 resolution (miles or Km).
This counter is automatically activated at the
fi rst impulse given by the speed sensor.
The datum is not stored permanently.
The counter linked to this parameter can be
reset by pressing (corresponding to the TD
function) the button for approx. 2 seconds,
until the value 000.0 appears.
TD can be reset when the vehicle is stopped
or moving.
If the number is higher than 999.9, the system
resets the TD and then restarts the count.
Note: In the absence of mains po-
wer, the TD value is irretrievably
lost.
GB
98

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Motard m4

Inhaltsverzeichnis