DAB NGPANEL Installations- Und Wartungsanleitungen Seite 62

14.2.3 Use level probes
Once the control type has been configured, see section 14.2.4 Concluding configuration.
14.2.4 Concluding configuration
The choice of exchange mode is necessary to prevent wear of a single pump.
If this function is not enabled during the Filling or Draining Configuration, it can no longer be activated. This
will only be possible by resetting to the factory data.
14.2.5 Enabling water volume estimation
Once configuration is complete, the system will be ready but in standby.
You can choose whether to access the "Main Menu" or set the "Optional Configurations".
Refer to the respective chapters 14.5 Main menu and 14.4 Optional configurations.
ENGLISH
Indicate the level probe as the type of control.
Pump exchange mode
One of the following intervals can be set:
- At restart
- Every 2 hours
- Every 4 hours
- Every 8 hours
- Every 12 hours
Enable water volume estimation function
To enable this function, refer to the chapter 14.2.5 Enabling water volume estimation. This
option, which is only available when using the depth sensor, allows you to monitor the
amount of liquid in the tank.
The system is ready
All the parameters have been set, the system is now in standby.
From here you can choose whether to access the "Main Menu" or set the
"Optional Configurations". Refer to the respective chapters 14.5 Main menu
and 14.4 Optional configurations.
Tank shape
You can set the shape of the tank from those listed:
- Parallelepiped
- Cylinder
Once the shape has been chosen, indicate the volume by setting the largest
side/diameter and the smallest side of the section.
52
- Every 16 hours
- Every 20 hours
- Every 24 hours
- Never